Flying Fish Half Mounts

Flying Fish are sought out by many pelagic species and if you have been out on the boat during the summer time and you're driving around you are sure to kick up some of these cool fish. Skimming over the top of the water to get out of troubles way and then diving back into the deep blue. These flying fish are perfect to stick in front of any mahi, sailfish or marlin mount. A school of flying fish even make for a good wall piece all by themselves. Our Flying Fish half mounts are anatomically correct half fish replicas that are intended to be displayed on the wall. A half sided mount is produced by casting the front part of our two sided wall mount molds. When displayed the circumference of the half mount is either touching the wall or very close to the wall. This process cuts labor and supplies cost and therefore results in a lower price point however the skin texture and finishing process is the same as a traditional full mount.

Flying Fish Half Mount Paint Schedule

We do not custom paint our half mounts but regular paint schedule is to paint the flying fish "lit up" and alive which is most likely what you are looking for and what most customers really appreciate. They have shiny blue bodies and blue-gray wings and the final step is to clear coat the flying fish with a UV Protective Urethane clear coat. These beautiful flying fish are perfect pieces of decoration for your new house, office or Florida room.

Shipping Your New Flying Fish Mount

Our packaging team is experienced and completely understand the importance of superior packaging to ensure a damage free transit. In the event that the shipping carrier decides to run over your package with their truck or something catastrophic happens we will instantly replace the damaged mount and please keep in mind all of our fish mounts come with a money back guarantee.

Installation Of Your Flying Fish Mount

Your new Flying Fish half mount will arrive with a resin hanger attached to the backside of the half mount that runs parallel to the ground. Hold the half mount up on the wall, mark the spot where the hanger touches the wall, drill in a couple screw or hammer in a couple nails and then hang your new Flying Fish half mount. If you are intending to put this outside permanently we do have some additional hardware options. Please contact us prior to ordering to discuss those costs.